Pressure switches are used to turn on and off the pump that supplies your water.

$ 16.75	FSG22040 FSG23050 FSG24060	FSG2 Square D Pumptrol pressure switches are the most widely sold switches on the market. Rated for up to 1-1/2 HP pumps at 115 Volt, or up to 2 HP pumps at 230 Volt. Factory preset pressure ranges of 20 psi on / 40 psi off 30 psi on / 50 psi off 40 psi on / 60 psi off
$ 25.75	FYG23050 FYG24060 FYG26080	FYG2 Square D pressure switches are rated for up to 2 HP at 115 Volt and up to 3 HP at 230 Volt. Factory preset pressure ranges of 30 psi on / 50 psi off 40 psi on / 60 psi off 60 psi on / 80 psi off
$ 69.00	GHG26080 GHG280100	GHG2 Extra large and heavy duty pressure switch terminal block. Maximum allowable pressure setting of 300 psi. Rated for 2 HP at 115 Volt, 3 HP at 230 Volt, and 5 HP at 460/575 Volt. Factory preset pressure ranges of 60 psi on / 80 psi off 80 psi on / 100 psi off

Furnas no longer makes the #69L1986 Double Pole Float Switch. We have replaced this item with the Square D Open Tank Float Switch, which performs like a mechanically activated pressure switch. However, Square D's Float Switch is not reversible like the old Furnas switch. These are rated up to 2 HP at 115 Volt, and 3 HP at 230 Volt.
$ 49.50	9036DG2R	Square D float switch opens the contacts on liquid rise, to control filling or pump up of a tank, ie turning the pump off when an open stock tank is full.
$ 49.50	9036DG2	Square D float switch closes the contacts on liquid rise, to control a pump down or empty tank, ie like a sump pump type operations.
$ 43.25	R4406	6" copper float with 1/4-20 SAE female thread and 3.26 lbs bouyancy. Use with a 5' long rod with stop collars.
$ 89.95		5' Brass Rod assembly with 2 stop collars
$ 11.95	Each	Extra Stop Collars

$ 23.00	FSG2M42040 FSG2M43050	FSG2 Form M4 combines the pressure switch with a low pressure cut-off switch. If the line pressure should drop to approximately 7 psi lower than the switch's cut-in setting, the low pressure cut-off will stop the pump. Should this happen, the lever on the side of the switch must be manually reset before the pump will operate again. Rated for up to 1-1/2 HP at 115 Volt and up to 2 HP at 230 Volt. Factory preset pressure ranges of 20 psi on / 40 psi off 30 psi on / 50 psi off
$ 42.50	GARDIT	GARD-IT Switch is the Furnas brand low pressure cut-off switch. Factory preset to disconnect power to the pump should the line pressure drop to 12 psi. The cut-off pressure is adjustable from 3 psi through 20 psi. Switch has a manual reset lever. Rated for up to 1 HP at 115 Volt and up to 2 HP at 230 Volt.
$ 95.00	OVERHEATSWITCH	OVERHEATSWITCH Installs on the pump case to sense case temperature. Sensor turns off the power to the pump when the temperature hits 120 degrees F, and resets to power the pump when the temperature drops to 110 degrees F.

$ 32.75	69WB3050	69WB pressure switch similar to the Square D FYG2 pressure switch. Rated for up to 2 HP at 115 Volt and up to 3 HP at 230 Volt. Factory preset ranges 30 psi on / 50 psi off
$ 39.95	69MC80100 69MC95125 69MC115150	69MC pressure switch similar to the Square D FYG2 pressure switch. Rated for up to 2 HP at 115 Volt and up to 3 HP at 230 Volt. Factory preset ranges 80 psi on / 100 psi off 95 psi on / 125 psi off 115 psi on / 150 psi off