| HEAT TAPE PRICES |
DEAN BENNETT SUPPLY |
||||||||||||||||||||
|
|
|
||||||||||||||||||||
|
WinterGard Information & Chart |
|
||||||||||||||||||||
|
WinterGard
Plus |
|
||||||||||||||||||||
|
WinterGard Wet for Roof Installation WinterGard Wet for Water Pipes Wintergard Wet Roof & Gutter Tape in pdf Wintergard Wet Heat Tape for Water Pipes in pdf H908 Plug Kit Installation Instructions in pdf
|
|
||||||||||||||||||||
|
Parallel circuitry allows current to
flow between the two bus wires independently at each point along the
heating cable. |
|||||||||||||||||||||
|
PRE-ASSEMBLED HEAT
TAPES |
||||
![]() |
![]() |
![]() |
![]() Pre-Assembled Heat Tapes with Plug and end seal installed. Choose the size |
|
|
W516P 6' Heat Tape |
W5112P 12' Heat Tape |
W5124P 24' Heat Tape |
W5150P 50' Heat Tape |
|
|
These pre-assembled heat tapes are
assembled with the 120V plug installed and are ideal for pipes and roof
edge where a heat tape is desired to keep snow and ice from building up on
roof edges or eaves. |
||||
| 6' #W516P |
6' pre-assembled heat tape
approved for wet locations. 120V |
$ 67.00 | ||
| 12' #W5112P |
12' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 85.00 | ||
| 24' #W5124P |
24' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 125.00 | ||
| 50' #W5150P |
50' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 218.00 | ||
| SPECIAL ORDER SIZES OF PRE-ASSEMBLED HEAT TAPES | ||||
|
18' #W5118P SPECIAL ORDER |
18' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 104.00 | ||
|
75' #W5175P SPECIAL ORDER |
75' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 308.00 | ||
| 100'
#W51100P SPECIAL ORDER |
100' pre-assembled heat tape approved for wet locations. 120V power for pipes and eaves. Must use a GFI power circuit. |
$ 395.00 | ||
| Roof
Top Snow & Ice Sensor Switch to Turn On Heat Tape to Prevent Buildup |
|
NEW
TO OUR STOCK |
| WinterGard Wet 230V heating cable is a
professional-grade, 6 watt per foot, self-regulating electrical heat cable that
can be used to protect pipe from freezing, or can be used for roof deicing. The
heating cable has a construction of nickel-copper bus wires, a self-regulating
conductive core, an insulated jacket, a tinned copper braid and an outer jacket
of polyolefin. There are several advantages to the Wintergard wet
self-regulating heat tape. It can be overlapped, you can cut it to length
without burn out, it saves energy and it will not overheat roofing material or
gutters when used to deice your roof. WinterGard Wet 230V can be used up to 350 feet to protect pipes for temperatures down to 0 degrees. You can also use it for gutters in lengths up to 250 feet. |
|
WinterGard Wet 230V H-622 #WGWHT230xCUT $
5.38 ft. |
|
WinterGard
H900 Power Connection Kit |
|
The WinterGard H900 Power
Connection Kit can be used to hard wire your heat tape to the power supply line.
This kit can be used with WinterGard 3 Watt 120V heat tape, WinterGard 6 Watt
120V heat tape, Wintergard Wet 6 Watt 120V heat tape and WinterGard Wet 6 Watt
230V heat tape. Do not use with aluminum feed wires. Kit contains one power
connection and one end seal. |
|
WinterGard H900 Power
Connection Kit
$ 27.25 |
|
Fixed Point Thermostat (40 degree F) |
|
AMCF5 Fixed point Thermostat is factory set for
40 degree F control of heat
tape. $
163.00 |
![]() |
Avoid Cold Weather Problems Thermo Cube is a device which plugs into a standard GFI protected 120V AC outlet to automatically control turning power on and off for heat tape or stock tank heaters. By plugging the device into the Thermo Cube, when the air temperature reaches 35 degrees F, the Thermo Cube will turn on the power. When the Air temperature gets up to 45 degrees F, the power will turn off. This makes your heat tape more efficient to operate, since you are not having to run the power all the time. According to the manufacturer, you can use the Thermo Cube to control heat tape or stock tank heaters that are rated up to 1800 watts maximum or 15 amps total on 120V GFI protected circuits. TC3 is 3-1/4" wide and 1-3/8" high and 1" thick, and has place for two 3 prong plugs to plug into it. TC3 Thermo
Cube Heat Tape Thermostat |
|
|
|
NEMA3 Rain Tight
Junction Box H921 H921 WinterGard 120 V heat tape junction box with ground fault equipment protection, for use with H900 Hard Wire Power Connection Kit. Junction box is rain tight. Excellent for use
with H612 WinterGard Wet heat tape when using on a roof or gutter to
make power connection where the potential for getting wet is present. |
|
|
|
||
![]() |
$ 137.00 #HTTHERMOSTAT |
ELECTRONIC TEMPERATURE
CONTROL 120V Electronic Temperature Control Electronic Temperature Control unit has a temperature differential range of 1 Degree F to 30 Degrees F. Unit can control temperatures from -30F to 220F, however you will not need the range capabilities of this control for use with heat tape for on your roof or on water pipes. |
|
|
|
Inside the Pipe Heat Tapes |
|
|
|
Protect buried water lines |
|
|
|
|
Current Controller |
New Controller (01/11) |
|
No Return of Merchandise |
|
Prices effective July 20, 2012 |