WINTERGARD
WET
HEAT TAPE
for Water Pipes

DEAN BENNETT SUPPLY
PH 800-621-4291



WinterGard Wet heat tape is designed for use at 120V using 6 watts per foot in a length as long as 200' maximum of heat tape. Depending on the temperature you must protect against, and the thickness of the closed cell insulation used on the pipe, the following chart applies. WinterGard Wet is much heavier duty than Frostex Plus heat tape, and can be used for those lengths longer than 50' in length. WinterGard Wet is 6 watt per foot of heat power to give more protection than even WinterGard 3 watt does. WinterGard Wet has a protective coating over the metal braid to protect it against moisture, allowing it to be used in damp or wet areas.

WinterGard Wet Heat Tape for Metal & Plastic Pipes

WinterGard Wet 120V 6 watt per foot heat tape is to be applied straight along the pipe. Chart indicates Metal when only able to use on Metal, and says Both when it can be used on both PVC and Metal pipe. When there is a number in the chart it indicates that you need to multiply your feet of pipe by that number to get the required feet of heat tape for the pipe being protected, and spiral it around the pipe. Indicated for the size of pipe and the thickness of closed cell insulation used on the outside of the pipe to protect to the desired temperature. Normally add 1' for plug and 1' for end fitting.
Insulation
Thickness
Metal & Plastic Pipe Size in Inches at 0 degrees F
1/2" 3/4" 1" 1 1/4" 1 1/2" 2" 2.5"
1/2" Plastic Plastic Plastic Both Both PVC x 1.2
Metal x 1.0
PVC x 1.4
Metal x 1.0
1" Plastic Plastic Plastic Plastic Plastic Plastic
1.5" Plastic Plastic Plastic Plastic
Metal & Plastic Pipe Size in Inches at - 20 degrees F ( below 0 )
1/2" Plastic Both PVC x 1.1 PVC x 1.3 PVC x 1.5
Metal x 1.0
PVC x 1.8
Metal x 1.1
PVC x 2.0
Metal x 1.3
1" Plastic Plastic Plastic Plastic Both PVC x 1.1
Metal x 1.0
PVC x 1.2
Metal x 1.0
1.5" Plastic Plastic Plastic Plastic Plastic Both
2" Plastic Plastic Plastic Plastic
Metal & Plastic Pipe Size in Inches at - 40 degrees F ( below 0 )
1/2" PVC x 1.1
Metal x 1.0
PVC x 1.1
Metal x 1.0
PVC x 1.5
Metal x 1.0
PVC x 1.8
Metal x 1.1
PVC x 2.0
Metal x 1.2
PVC x 3.0
Metal x 1.4
PVC x 3.0
Metal x 1.7
1" Plastic Plastic Both PVC x 1.1
Metal x 1.0
PVC x 1.2
Metal x 1.0
PVC x 1.4
Metal x 1.0
PVC x 1.6
Metal x 1.0
1.5" Plastic Plastic Plastic Plastic Both PVC x 1.1
Metal x 1.0
PVC x 1.2
Metal x 1.0
2" Plastic Plastic Plastic Plastic Plastic Plastic Both

NEW TO OUR STOCK
Wintergard Wet 230V Heat Tape

WinterGard Wet 230V heating cable is a professional-grade, 6 watt per foot, self-regulating electrical heat cable that can be used to protect pipe from freezing, or can be used for roof deicing. The heating cable has a construction of nickel-copper bus wires, a self-regulating conductive core, an insulated jacket, a tinned copper braid and an outer jacket of polyolefin. There are several advantages to the Wintergard wet self-regulating heat tape. It can be overlapped, you can cut it to length without burn out, it saves energy and it will not overheat roofing material or gutters when used to deice your roof.
WinterGard Wet 230V can be used up to 350 feet to protect pipes for temperatures down to 0 degrees. You can also use it for gutters in lengths up to 250 feet. 

WinterGard Wet 230V #WGWHT230xCUT                                                $ 4.94 ft.

WinterGard H900 Power Connection Kit

The WinterGard H900 Power Connection Kit can be used to hard wire your heat tape to the power supply line. This kit can be used with WinterGard 3 Watt 120V heat tape, WinterGard 6 Watt 120V heat tape, Wintergard Wet 6 Watt 120V heat tape and WinterGard Wet 6 Watt 230V heat tape. Do not use with aluminum feed wires. Kit contains one power connection and one end seal.

WinterGard H900 Power Connection Kit                                                    $ 25.05

HOME          PRICE SHEET

WinterGard Wet is able to be used on pipe as large as 8" diameter. Call us for further details on larger sizes than shown in our chart.

Download our catalog in pdf format

No Return of Merchandise

Prices effective July 25, 2010